H3C CFP Transceiver Modules Installation Guide (6PW102)

Chapters Download

H3C CFP Transceiver Modules Installation Guide (CH&EN, 6PW102)

Read this guide carefully before installation to avoid transceiver module damage.

The appearances of the 40G CFP and the 100G CFP transceiver modules are different. Figures in this installation guide use the 40G CFP transceiver module for illustration.

Preparing for installation

Before you install or remove the CFP transceiver module, always wear an ESD wrist strap and make sure the wrist strap makes good skin contact and is well grounded.

Installing and removing the CFP transceiver module

 

CAUTION-一纸通

CAUTION:

·   After you install the CFP module, do not remove the dust plug if you do not connect a fiber cable to the module.

·   Do not plug a CFP transceiver module installed with a fiber cable into the CFP port.

 

Unsmooth installation for the 40G CFP transceiver module is likely to occur due to the bump design on its top.

Installing the CFP transceiver module

1.   Remove the dust plug from the CFP transceiver module.

2.   Align the CFP transceiver module with the CFP port, and push it into the port until the CFP transceiver module makes close contact with the port. (See Figure 1.)

 

CAUTION-一纸通

CAUTION:

If you install the CFP transceiver module in a wrong direction, the CFP transceiver module cannot be fully seated into the CFP port.

 

3.   Fasten the captive screws on the CFP transceiver module to secure the module into the CFP port. See callout 2 in Figure 1.

Figure 1 Installing the CFP transceiver module

(1) Push the transceiver module into the CFP port

(2) Fasten the captive screws

 

Removing the CFP transceiver module

1.   Disconnect the fiber cable from the CFP transceiver module.

2.   Loosen the captive screws on the CFP transceiver module. See callout 1 in Figure 2.

3.   Pull the CFP transceiver module out of the CFP port. See callout 2 in Figure 2.

4.   Install the dust plug to the CFP transceiver module.

Figure 2 Removing the CFP transceiver module

(1) Loosen the captive screws

(2) Pull the transceiver module out of the CFP port

 

Verifying the installation

1.   Use the display transceiver interface command to examine the installation. If the transceiver module information is correctly displayed, the transceiver module is installed correctly. If you are prompted error, remove the transceiver module and install it again.

2.   Enter the interface view of the target transceiver module, and use the display this command to examine the interface status. If the interface has been shut down, use the undo shutdown command to activate it.

Technical support

Hangzhou H3C Technologies Co., Ltd. provides customers with comprehensive technical support and service. If you purchase the products from the sales agent of Hangzhou H3C Technologies Co., Ltd., please contact our sales agent or technical personnel.

 

Address: 310 Liuhe Road, Zhijiang Science Park,

Hangzhou, Zhejiang Province, P. R. China

Postal code: 310053

Website: http://www.h3c.com

E-mail: service@h3c.com

BOM: 3105A01Q